Turning Milling Keyways 5-Axis CNC Finish & Rough Machining

Home | |  Services  | |  Products  | |  Quotes  | |  Contact  | |  Resources & Tools |

 

Akron Gear and Engineering Machining

Akron Gear is much more than a gear shop. We also posses the equipment to meet your machining needs. From 1/2" diameter shafts and spindles to 50,000 pound bases, Akron Gear has the right machines to meet the challenge.

Wire Drum Machining

Our exceptionally large machining capacity gives us an edge over our competition in the fact that we can not only cut the gears for your equipment, but we also manufacture the blanks, and in many cases manufacture and machine the mating parts to insure a quality fit with the final product.

 

Turning

Akron Gear has an excellent track record with large part turning. Large gear blanks, wear rings, spacer plates, rotors, fans, hubs and fabrication components are just a fraction of the parts that Akron Gear routinely turns for our customers. We understand that a finished product is only as good as the parts put into it, and we take as much pride in quality parts as you do.

Akron Gear can turn parts up to 110" in diameter and 110" tall on our vertical torrent lathes. Shafts are also no problem with lathe capabilities up to 25" in diameter and 100" long.

We not only turn large parts, but also machine small parts on our CNC lathes. We can parts as small as 1/2" diameter.

Milling

Akron Gear's milling capabilities are unrivalled with our Juaristi 5-axis CNC Boring Mill, capable of machining parts up to 50,000 pounds and nearly 100 cubic inches. Crank gear trunions, wire drums, bases, housings and intricate shaft machining are common place items on our three boring mills.

Gear blanks are only a small part of our machining potential.Other

Turning and milling are not our only areas of performance when it comes to machining your parts.

Akron Gear routinely assist other gear shops with our keyseating capabilities of up to 3" wide keys and 25" key strokes.

Grinding, drilling, threading and slotting help to round out our machining abilities at Akron Gear.

Sizes

bullet VTL Turning Up To 110" Diameter and 110" High
bullet Lathe Turning Up To 25" Diameter and 100" Long
bullet 5 Axis CNC Machining Up To 50,000 pounds (Approximately 100" X 100" X 100")
bullet Keyseating Up To 3" Wide X 25" Stroke
bullet Slotting
bullet Grinding
bullet Drilling

Materials

bullet Alloy & Carbon Steel
bullet Grey & Ductile Iron
bullet Stainless Steel
bullet Brass
bullet Bronze
bullet Plastic
bullet Micarta

Contact Akron Gear And Engineering Today For A Price Quote On Your Machining Needs.


Visit Our Tools and Resources Page For Great Information On Gear Cutting And Machining


 

 

Home | |  Services  | |  Products  | |  Quotes  | |  Contact  | |  Resources & Tools | |  Site Map  |


Copyright 2004 Akron Gear & Engineering, Inc - All Rights Reserved


Best Viewed with Internet Explorer 5+     800-600 Resolution