Radicon Series A Gearboxes
The Series A comes in Junior, Midrange,
and Heavy Duty ranges. Units can be mounted in the worm under, worm over
and gearshaft vertical mounting positions and provide a choice of shaft
arrangements. Series A gives a choice of 12 standard ratios from 5:1 to
70:1, 14 standard ratios in the Heavy Duty from 5:1 to 70:1.
Cone Drive - Radicon Series A Junior Gearbox
Series A Junior is offered in unit
sizes 280, 410, 510, 610, 730 and 860 based on a single universal case
for each size, giving a high degree of common parts and
interchangeability. Motors can be close coupled in frame sizes 56C to
215TC in powers from 0.19 kW or 0.25 HP to 7.5 kW or 10 HP.
All units are designed with hollow
output bores, output shafts can be fitted allowing hand of assembly to
be changed without dismantling the unit. Double extended output shafts
are also available. All Junior units are lubricated for life to reduce
maintenance to a minimum.
Click Here To Download The Series A Junior Gearbox Catalog
Cone Drive - Radicon Series A Mid-Range Gearbox
Series A Midrange is offered in unit
sizes 1002, 1252, 1602 and 2002 based on a single universal case for
each size, giving a high degree of common parts and interchangeability.
The Midrange meets the requirements of a wide variety of applications in
the medium power range up to 75kW or 100 HP. All units are designed with
hollow output bores, output shafts can be fitted allowing hand of
assembly to be changed without dismantling the unit.
Click Here To Download The Series A Mid-Range Gearbox Catalog
Cone Drive - Radicon Series A Heavy Duty Gearbox
Series A Heavy Duty units provide power
capacity up to 835 kW or 1120 HP in 11 sizes from 400 to 24 with worm
gear centers from 10cm to 61cm or 4" to 24". Motorized versions of all
units are also available.
All units are fitted with high capacity
tapered roller bearings for generous overhung loads, position action oil
seals, oil level sight glass and drain holes. Flange mounted units with
vertical downshaft have drywells fitted as standard to eliminate a head
of oil on the low speed shaft seal and prevent oil leakage. Upper and
lower speed shaft bearings are grease lubricated when drywells are
fitted. All units can be supplied with holdbacks. Shaft extensions can
be supplied with metric or inch dimensions.
Click Here To Download The Series A Heavy Duty Gearbox Catalog
Unit Sizes: 280, 410, 510, 610, 730, 860, 1002, 1252, 1602, 2002,
10, 12, 14, 17, 20, and 24
Input Power: Up to 835 kW or 1,120 HP
Output Torque: Up to 100,000 Nm or 885,000 Lb. In.
Gear Ratios: From 5:1 to 160:1 in single reduction, 4,900:1 in
Motor Sizes: NEMA Frames from 56 to 215 or IEC Frames from 63 to